The pilot of a Boeing 747 jumbo jet mistakenly landed at a small Kansas airport not far from the Air Force base where it was supposed to deliver parts for the company's new 787 Dreamliner.
The 747 intended to touch down at McConnell Air Force Base in Wichita, which is next to a company that makes large sections of the 787.
Instead, the cargo flight landed 8 miles (13 kilometres) north, at the smaller Col. James Jabara Airport.
Hours later, the jet took off again and was expected to land at its original destination.
The plane landed in an area where there are three airports with similar runway configurations: the Air Force base, the Jabara airfield and a third facility in between called Beech Airport.
Boeing owns the plane, but it's operated by Atlas Air Worldwide Holdings, a New York-based cargo-hauler that also provides crews or planes to companies that need them.
Atlas Air spokeswoman Bonnie Rodney declined to answer questions and referred inquiries to Boeing.
"We are working with Atlas Air to determine the circumstances," Boeing said in a written statement.
The Federal Aviation Administration planned to investigate whether the pilot followed controllers' instructions or violated any federal regulations.
The pilot sounds confused in his exchanges with air traffic control, according to audio provided by LiveATC.net.
"We just landed at the other airport," the pilot tells controllers shortly after the landing.
Once the pilot says they're at the wrong airport, two different controllers jump in to confirm that the plane is safely on the ground and fully stopped.
The pilot and controllers then go back and forth trying to figure out which airport the plane is at. At one point, a controller reads to the pilot the co-ordinates where he sees the plane on radar. When the pilot reads the coordinates back, he mixes up "east" and "west."
"Sorry about that, couldn't read my handwriting," the pilot says.
A few moments later, the pilot says he thinks he knows where they are. He then asks how many airports there are to the south of McConnell. But the airports are north of McConnell.
"I'm sorry, I meant north," the pilot says when corrected. "I'm sorry. I'm looking at something else."
They finally agree on where the plane is after the pilot reports that a smaller plane, visible on the radar of air traffic control, has just flown overhead.
The modified 747 is one of a fleet of four that hauls parts around the world to make Boeing's 787 Dreamliner. The "Dreamlifter" is a 747-400 with its body expanded to hold whole fuselage sections and other large parts. If a regular 747 with its bulbous double-decker nose looks like a snake, the bulbous Dreamlifter looks like a snake that swallowed a rat.
According to flight-tracking service FlightAware, this particular DreamLifter has been shuttling between Kansas and Italy, where the centre fuselage section and part of the tail of the 787 are made.
McConnell is next to Spirit AeroSystems, which also does extensive 787 work. The nearly finished sections are then shipped to Boeing plants in Everett, Washington, and North Charleston, South Carolina for assembly into finished airplanes. Boeing is on track to make 10 of them per month by the end of this year.
Because 787 sections are built all over the world - including wings made in Japan - the Dreamlifters are crucial to the 787's construction. Boeing says the Dreamlifter cuts delivery time down to one day from as many as 30 days.
Although rare, landings by large aircraft at smaller airports have happened from time to time.
In July last year, a cargo plane bound for MacDill Air Force base in Tampa, Florida, landed without incident at the small Peter O Knight Airport nearby. An investigation blamed confusion identifying airports in the area, and base officials introduced an updated landing procedure to mitigate future problems.
The following month, a Silver Airways pilot making one of the Florida airline's first flights to Bridgeport, West Virginia, mistakenly landed his Saab 340 at a tiny airport in nearby Fairmont.
The pilot touched down safely on a runway that was just under 3200 feet (975 meters) long and 75 feet (23 metres) wide - normally considered too small for the passenger plane.
Thursday, 21 November 2013
Dreamlifter 747 delivers Dreamliner parts to wrong airport
Subscribe to: Post Comments (Atom)
Amelia Earhart's sad demise
Dozens heard Amelia Earhart's final, chilling pleas for help, researchers say Distilled from 2 posts in the Washington Post a...
Dakota Part 5: Douglas AC-47 Spooky / Puff, the Magic Dragon / Dragon Dak The Douglas AC-47 Spooky (also nicknamed "Puff, the ...
Red 8: The only Surviving Me 262B-1 Night fighter (Nachtjaeger) Surviving samples of the world's first operational jet fighter are ...
Dassault Mirage F1 in SAAF Service: Part 2 The Border War Obtaining new combat aircraft from abroad for the SAAF became almost i...
Post a Comment